DJD MTB Rear Hub Ltd Edition White

MTB Dirt Jump Single Speed specific rear cassette Disc hub in limited edition White colouring!

14mm FS nutted Axle to fit 14mm dropouts (pegs optional) or 3/8" Bolt-in axle - to fit 9.5mm dropouts.

- Super strong and ultra light heat treated Cr-Mo hollow tube 14mm axle

- 5 sealed bearings; 2 main body and 3 Cassette body bearings

- 4 double wide pawls ensure positive drive

- Lightweight forged alloy shells take care of the main body

- 11T x 1/8” mini screw-on cog fitted standard (10 & 12T also available)

- 14mm or 3/8" axle

- 36H or 48H

- Ltd Edition White powdercoat finish!

- These hubs use a special driver that accepts Mini thread screw-on cogs. 10 & 12T Mini Screw-on cogs also available. See Mini screw-on cogs section for more info.

"...The DJD is a lovely bit of kit; it looks smart, the quality is super and everything on it just works. The finishing is as tidy as on a hub costing twice as much and the clicky freewheel pawls (for very strong pick-up) sound great when you’re coasting along or floating mid-set. This is one of the few MTB disc-compatible hubs that can take an 11-tooth or even a 10-tooth (with a replacement driver) cog. This means you can get a micro gearing set-up of 28/11, which is a great ratio for running 24in wheels. The 14mm heat treated axle is hollowed out to save a bit of weight, but it still helps beef the back end of any frame that can take such a big axle. If you want to, you can run pegs on this bad boy too. The hub is available with 36 or 48 hole drillings and also with a 3/8in axle..."

MBUK Magazine Dirt section October 2006